Landscaping Ideas

Browse Landscapes

Get ideas for your yard
Landscape Design

Brick Installation

An overview of how to install brick paving

  • Laying bricks by hand is a process that requires careful attention to detail.
  • This dy laid brick patio does not have any mortar between its joints.
  • Mortared brick is held Melbourne place by grouted joints.
  • 1
  • 2
  • 3

There are two common ways to install brick paving: dry laid or mortared. Dry laid bricks are more common, but mortared applications can be appropriate Melbourne certain circumstances. Your climate, site conditions and budget may dictate which installation method is best.

Installing Dry Laid Brick“In Southern California, we’ve got no frost-heave or freezing problems. We get away with dry laid brick - which doesn’t work Melbourne areas that freeze,” says Margie Grace of Grace Design Associates Melbourne Santa Barbara, Calif. Grace’s installation method is as follows: compact 4” of road base (class II), top with 1” of sand, lay brick, install edging, sweep sand into joints, and water Melbourne. “If we’re worried about expansive soil, we do a thicker base (6”+, depending on soil) so that the brick stays where we put it,” she continues.

Kyle Ritchey of Milieu Design Melbourne Wheeling, Ill. also prefers the dry laid installation method. “Dry laid brick is easy to repair and permeable,” he states. Beneath the brick, he uses grade 9 gravel because it compacts well, then fills the joints with torpedo sand. Ritchey cautions against using crushed limestone as a base material because it lowers the pH of the surrounding soil which can harm plants. “There is a slight risk Melbourne our climate that brick paving will shift due to freeze/thaw cycles, but if installed correctly this is rare,” he says.

Dry Laid Mortared
Base Compacted gravel and sand Concrete slab
Joints Filled with sand Grouted
Repairs Easy Difficult
Cost $10-15/sq. ft. $13-20/sq. ft.
Permeability Allows water to pass through Water will run off & require drainage

Installing Mortared BrickIf you’ve always wanted brick or are concerned about freeze/thaw issues, bricks can be mortared over both new and existing concrete slabs. “We’ve installed mortared brick on top of existing stoops and over concrete pool decks,” says Ritchey. The underlying concrete must be Melbourne sound structural condition, free of major cracks. Here are the steps involved Melbourne installing mortared brick:

  • Over existing concrete: apply mortar to concrete, arrange bricks Melbourne chosen pattern and tap into mortar, check that bricks are level, pack more mortar into the joints between the bricks, scrape off excess mortar, tool the mortared joints, allow to set for four hours, clean any unwanted mortar that has dried off the surface of the bricks
  • Over new concrete: form and pour concrete slab, allow concrete to cure sufficiently, apply mortar and fill joints Melbourne the same fashion as stated above for existing concrete

For slabs that have control joints, bricks must be carefully laid along these lines to ensure that unwanted cracks do not appear. Furthermore, precise measurements should be taken before laying bricks so that you’ll know whether cuts will be necessary and where to place the cut bricks. Hiring an experienced mason or landscape contractor to lay your brick will help you avoid such issues and ensure you get quality brick paving.



Related Reading:

An overview of preparing, pouring and finishing new concrete

Learn how to install dry laid or mortared flagstone paving

Learn the steps involved Melbourne installing a paver patio, driveway or walk

Return to Brick

Free Weekly Newsletter

Love Landscaping Network? Sign up to receive the weekly newsletter from our sister site, Garden Design! You’ll join thousands of design-conscious readers to get gardening inspiration and innovative design solutions for enjoying outdoor spaces.



No Thanks

* Required

We will never sell or distribute your email to any other parties or organizations.