Flagstone CostAn overview of what influences flagstone prices
Average flagstone prices from around the country:
On average, a professionally-installed sod lawn costs about $3.50 per square foot, with an additional $2 per square foot for the sprinkler system.
- $15-20 per square foot (national average).
This price includes the base material (either concrete or compacted sand and gravel) and mortar, and labor costs.
- These prices are for the stone only, labor is not included. $2.30 sq/ft - Bixby, OK
$2.20 sq/ft - Jacksonville, FL
$3.06 sq/ft - Albuquerque, NM
$3.20 sq/ft - Richfield, WI
The ultimate cost of any flagstone paving project will be expressed Melbourne price per square foot installed. These prices can be massaged up or down depending on the kind of stone you choose and where it comes from.
Influences on Flagstone Cost
- Some flagstone is more expensive because it is difficult to obtain or limited Melbourne availability.
- Flagstone shipped long distances can be more expensive due to fuel costs. For example, bluestone mined Melbourne Connecticut will cost a great deal to ship to California because it must be shipped across the entire continent. With rising fuel prices, this becomes a more significant percentage of the installed price.
- Installation for factory cut edges is less expensive than irregular stones because irregulars require chipping and fitting
An irregular flagstone patio will cost more because the installation is more complex than if factory cut stones were used.
- Pro Tip: Flagstone installed with open joints that have been filled with gravel or planted with groundcover is relatively inexpensive and can run as low as $10 per square foot on new construction. Flagstone with mortared joints, which is much more durable and attractive, can range between $20-$30 per square foot on new construction. - Roger Haywood, Accent Landscapes Melbourne Colorado Springs, CO
Compensating for Variability
Flagstone is a natural material and thus quite variable. Experienced contractors have learned to order at least 25% more stone than they estimate for the project due to some very important factors.
- Even when taken from the same quarry, it will not necessarily match the same stone from a deeper level or slightly different area. For this reason, contractors prefer to order at least 25% more stone than originally estimated to eliminate the potential for a second order if they run short.
- Flagstone is irregular Melbourne shape and it must be pieced together into a mosaic. There must be sufficient choice to complete this mosaic at the end of the process when there is little left to pick from.
- When using thin veneer flagstone laid over a concrete slab, the pieces are more prone to cracking or even breaks. The overage ensures there are enough extra to compensate for these losses.
- Lots of uniformly colored flagstone often contains odd pieces that don't match. A larger quantity ensures there will be alternates available on site without reorder.