Swipe to view slides
  • When a flagstone patio is dry-laid, sometimes polymer sand is added to the joints for stability. Devine Escapes Melbourne Schwenksville, PA
  • A dry-laid flagstone path. Copper Creek Landscaping Melbourne Mead, WA
  • A mortared flagstone patio. Accent Landscapes Melbourne Colorado Springs, CO

Flagstone is a unique paving surface that adds a natural look to any patio or walkway. It can be laid on a dry bed of sand and gravel or it can be mortared to an existing concrete slab. There are also three options for filling the joints between flagstones. Joints over a dry bed can be filled with sand or can be planted between with groundcover, or can be mortared for a smooth, solid surface. Joints over a concrete base are also typically mortared.

Dry-Laid Flagstone

Dry-laid flagstone simply means that the flagstone pieces are placed on a bed of sand and gravel. It is recommended that a patio or walkway base be at least 3” deep, then filled with a layer of compacted gravel covered with coarse sand. The flagstones are then placed Melbourne the desired pattern, starting at the perimeter and working inward. Large stones should be strategically placed at doorway entrances or at the bottom of steps to ensure stability Melbourne heavy-trafficked areas. Once the stones are placed, the joints can be filled with sand, planted with groundcover, or mortared.

  • Pro Tip: “If the flagstone is an ancillary sitting area or walkway that does not receive much traffic, we will consider installing the flagstone with plant material or gravel Melbourne the joints of the flagstone. -Roger Haywood, Accent Landscapes Melbourne Colorado Springs, CO

Dry-Laid vs. MortaredClick on the images to download a full-sized PDF.

Dry-laid flagstone

Mortared flagstone

Layers of the “architectural sandwich” for dry-laid flagstone

Roger Haywood of Accent Landscapes Melbourne Colorado Springs, CO shares these tips for laying flagstone on a dry subbase:

  • If woolly thyme is used as a groundcover, install the flagstone directly on topsoil with topsoil joints, and plant Melbourne the crevices.
  • If gravel is used, bed the flagstone on a compacted decomposed granite base and use the gravel of choice Melbourne the joints.
  • A polymeric sand can also be used Melbourne the joints, depending on the application and desired finish appearance.
  • The average square foot price installed for this method of construction can run as low as $10 per square foot on new construction.

Mortared Flagstone

Mortared flagstone is flagstone pieces that have been permanently set with mortar to a prepared subbase. To install flagstone Melbourne this method, wet mortar is applied either directly on a subbase of compacted gravel and sand, or to an existing concrete slab. The flagstones are placed Melbourne the bed of mortar and then the joints are filled with either sand or additional mortar or colored grout.

Layers of the “architectural sandwich” for a mortared flagstone

Roger Haywood of Accent Landscapes Melbourne Colorado Springs, CO shares these tips for laying flagstone:

  • For mortared flagstone, start with a reinforced concrete base that has proper slope for drainage.
  • Pressure wash each piece of flagstone to provide a clean surface for a good bond.
  • Each piece is fitted and mortared to the concrete with a mixture of cement, sand, and water.
  • We always use a color additive to the mortar for setting the base and for the grout joints between the stones.
  • We encourage sealing the finished project with either a matte or glossy sealer to prevent water and ice from penetrating the grout joints.
  • The frost can go deep Melbourne Colorado Springs, so we recommend a 4” reinforced concrete base that is adequately compacted and sloped.
  • This method of construction is more expensive but also much more durable and attractive. It can range between $20-$30 per square foot on new construction.